1. Disconnect the cable from the USB port and make sure the NS7 / V7 is off. While holding the right Deck's HOT CUE BUTTONS 1 and 3, turn the NS7's / V7's power on. HOT CUE BUTTONS 1-5 should flash twice.

2. Wait 10-20 seconds.

3. Set all faders and knobs to the maximum or right-most position. The PITCH FADERS should be at the bottom, which is their maximum.(See image below) The left Deck's HOT CUE BUTTON 1 will light up.

4. Press the lit left Deck's HOT CUE BUTTON 1. It will flash twice.

5. Set all faders and knobs to the minimum or left-most position. The PITCH FADERS should be at the top, which is their minimum.(See image below) The left Deck's HOT CUE BUTTON 1 will light up.

6. Press the lit left Deck's HOT CUE BUTTON 1. It will flash twice.

7. On the left Deck's STRIP SEARCH sensor:

• Touch and hold the right-most position. When the left Deck's HOT CUE BUTTON 1 lights up, press it. It will flash twice.

• Touch and hold the left-most position. When the left Deck's HOT CUE BUTTON 1 lights up, press it. It will flash twice.

• Touch and hold the exact center position. When the left Deck's HOT CUE BUTTON 1 lights up, press it. It will flash twice.

8. Repeat Steps 8a-c with the right Deck's STRIP SEARCH sensor.

9. Set all faders and knobs to the middle/center position.(See image below) The left Deck's HOT CUE BUTTON 1 will light up.

10. Press the lit left Deck's HOT CUE BUTTON 1. The left Deck's HOT CUE BUTTONS 1-5 will flash, indicating that calibration is complete.

11. Turn the NS7's / V7's power off then on again before reconnecting it to your computer.